Skip to content
Architectural shingles installed by a careful crew (470) 762-1508
Duluth Roofing Experts logo

Metal roof systems

Metal Roofing in Duluth, GA

A metal roof planned for your home's pitch and style, with trim and fasteners matched to the system and installed with care.

Close-up of a ribbed metal roof edge over a wood wall

Does Your House Suit Metal?

Metal roofs cost more up front than shingles, but many homeowners choose them because they last a long time, shed rain and leaves quickly, and resist wind better than most other materials. A metal roof can also reflect more summer heat than a dark shingle roof, which helps an attic run cooler. The decision is not right for every house, though, and we will talk it through honestly. A roof with lots of valleys, dormers and short runs takes more labor and trim, while a simple gable roof is a natural fit. During the free inspection we look at the pitch, the layout and the condition of the decking, and we explain which panel style suits the home and what it means for the budget. Installation follows the manufacturer's details closely: the right underlayment, closures at the ridge and eaves, matched trim at every edge and fasteners driven to the correct depth so the washers seal without being crushed. Metal can be slippery and sharp, so our crew sets up the work area carefully and keeps the yard clear of offcuts until the last panel is in place.

What a Metal Roof Installation Includes

Every metal roof is a system, and each piece has a job to do.

  • Fit check

    An honest look at whether your roof layout suits metal before you spend a dollar.

  • Deck and underlayment

    Decking checked and a high-temperature underlayment laid beneath the panels.

  • Panels sized to the roof

    Panels measured and cut for each slope with clean, straight runs.

  • Matched trim

    Eave, rake, ridge and valley trim matched to the panel system.

  • Correct fastening

    Fasteners set to the right depth so washers seal without cracking.

  • Ridge and eave closures

    Closures that keep out rain, insects and wind-driven debris.

  • Clean site

    Metal offcuts and screws collected every day, with a magnetic sweep at the end.

How a Metal Roof Gets Done

  1. Inspect and advise

    We look at the roof's layout and condition and tell you plainly whether metal is a good fit.

  2. Choose style and color

    You pick the panel style and finish, and we write an itemized quote and confirm the start date.

  3. Install and walk the job

    The old roof comes off, the metal goes on to spec, and the crew lead tours the result with you.

Metal Handled With Care

  • Straight advice

    If shingles would serve your home better, we say so before you commit to metal.

  • Safe handling

    Sharp panels and slick surfaces are handled with care, and the work zone stays roped off.

  • Details done right

    Trim, closures and fasteners are installed the way the system was designed to work.

  • Honest fit check
  • Matched trim
  • Fasteners set to depth
  • Offcuts cleared daily

Curious What Metal Would Cost?

We will look at your roof, explain the options and give you a written quote you can compare against shingles.